Novtek Tile Adhesive
Power Grip
NOVTEK POWER GRIP is a high performance polymermodified tile adhesive for preventing vertical slippage of large, heavy, natural and synthetic decorative stones, and tiles
For all types of natural and synthetic decorative stones and tiles.
- Prevents tile cracks and bonding failure
- High Standing and Adhesive tensile strength
- Resistant to slip with long open time
- Easy workability and longer pot life
- Lower labor cost and reduced installation time
- For interior and exterior tile installations
- Can hold tile sizes over 30cm x 30cm
- Conforms to European Standard EN 12004 Type C1
FORM : powder
COLOR : Gray & White
WATER/POWDER
RATIO : 5 1/2 – 6 Liters of Water for 25 kg
( *Water ratio may vary depending on weather
condition. )
CONSISTENCY : homogenous paste mortar
PACKAGING : 25 kg/bag
POT LIFE: 3-4hours
VOC Content: Very low odor
COVERAGE AREA: 4-6 m2
( *but depends on substrate condition ,
thickness of application and size of tiles )
SHELFLIFE: 12 Months
SURFACE PREPARATION
Surface must be fully cured, clean, dry and free from contaminants.
MIXING INSTRUCTIONS
• Pour 5 1/2 – 6 liters of clean water into a plastic pail and add one 25-kg bag of NovTek Heavy Duty Tile Adhesives.
• Always put water first in the container before adding NovTek Tile Adhesive for proper preparation.
• Mix thoroughly until a trowelable consistency is attained.
• Let stand for about 10 – 15 minutes, and then re-mix again.
APPLICATION
• Using a special notched trowel (6mm x 12mm) spread over 1-2 square meter area at a time only.
• Lay down tiles and adjust accordingly. Use tile spacers to ensure the correct spacing of the tiles.
• Ensure that the spread adhesive is used in 25-30 minutes maximum.
• Regularly check adhesive bed to ensure that no film layer has formed on the surface. If so disregard,
mix and spread a new batch straight from the mixing pail.